Now I cannot get it functioning correctly again. Once it is setup as an access point there was no way to login to admin it so I reset it. Is that correct? This router use to have machines plugged into it and it was working fine. From what I understand I cannot assign the router's internal IP to the same subnet or else it cannot properly route. Since that is coming from the Internet Router, the wireless router sees that as the external or internet address. I want to assign the rounter a static IP so I can always find it to admin it. I tried turning off DHCP on the router and changing the mode from Gateway to Router (as it is not acting as a gateway.) and still unable to grab a 10.x address with the PC plugged into it. If nothing happens when you plug it in, look for the switch and turn it on. Some Linksys routers have a hardware on/off switch. Connect the mains adapter to the router, plug it in and power it on. If DHCP is on then the PC hooked up to the router gets a address and can get to the Internet but in now on its own network segment. Connect a LAN (or Ethernet) port on the router to your computer using another Ethernet cable. After I do that and try to renew the IP on the PC plugged into the router, it says it cannot find the DHCP server. I logged into the wireless router and turned off DHCP. I just want the wireless to act as an access point so wireless devices can get Internet and access to servers etc. I have a Linksys wireless router that I want to plug int the same switch that the Internet router is plugged into. Our Internet router handles DHCP and assigns 10.1.10.x addresses. This should be easy but for some reason cannot get the configuration correct.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |